Understanding the relationship between Si alloying and corrosion performance of ZnAlMg coatings

02.11.2026
← Knowledge Hub

Research publication

Coatings and thin filmsCorrosionMetals and steel

The impact of Si addition on the microstructure and corrosion behavior of ZnAlMg coatings prepared in a laboratory simulator using several thermal application regimes for each coating composition is described.

Year
2026
Authors / speakers
Václav Šefl
Jan Švadlena
Ville Saarimaa
Lucia Suarez
Tomáš Prošek

Abstract

The impact of Si addition on the microstructure and corrosion behavior of ZnAlMg coatings prepared in a laboratory simulator using several thermal application regimes for each coating composition is described. The coatings exposed to a cyclic accelerated corrosion test Volvo ACT II were evaluated in view of mass loss, kinetics of white and red rust formation, and release of soluble ions. Both Si addition and the thermal regime affected the coating behavior. The best corrosion stability provided Zn3.7Al3Mg3Si with the microstructure consisting almost exclusively of very fine binary and ternary eutectics. The electrochemical role of particular phases was studied using a modified ZRA setup. Mg2Si was an important electrochemical actor serving as the principal anode in the early stage of the corrosion process. After its capacity as the source of Mg2+ had been expended, it was replaced by MgZn2.

Material and sources

DOI: 10.2139/ssrn.6614770

View original resource ↗

  • Top Analytica Oy Ab
  • Ruukinkatu 4, 20540 Turku, Finland (Old Mill courtyard)
  • Phone: +358 2 2827780
  • E-mail: info@topanalytica.com
Copyright © 2026 Top Analytica Oy Ab